fbpx

Bathroom & Sanitary Silicone Sealant

From $8.50

Anti-mold Bathroom & Sanitary Silicone Sealant Alseal AS-206

Description

ALSEAL AS-206 Bathroom & Sanitary Silicone Sealant is a one-component, mildew-resistant, 100% neutral-cure silicone sealant formulated for applications in areas with high humidity and temperature. The fungal resistance property of this sealant has been tested against ASTM G21-02 and found to have a strong fungistatic effect. It will cure to form a durable, flexible, waterproof seal on most common wet area building materials. It is tested to have a low VOC content, in compliance with the SCAQMD Rule 1168 (Adhesive and Sealant Applications).

 

Bathroom & Sanitary Silicone Sealant is widely use for grouting ceramic tiles, bedding tile accessories, and sealing showerheads, tubs, rimless, sinks, kitchen, and bathroom fixtures.

  • 100% neutral silicone
  • ASTM G21 tested
  • Mildew resistant (Anti-fungus)
  • Permanently flexible
  • Indoor and outdoor use

More information about product www.alseal.com.au

Additional information

WeightN/A
DimensionsN/A
Color

, , , ,

Package

20 pcs sausages box, 24 pcs cartridges box, Cartridge, Sausage

Technical Information

Technical Data

Curing system: Moisture curing, neutral
Specific gravity: 0.98 – 1.02
Slump (ASTM D2202): <1 mm
Tensile strength (ASTM D412): >0.9 N/mm²
Elongation at break (ASTM D412): >300 %
Shore A hardness (ASTM C661): 20 – 30
Anti-fungal testing (ASTM G21): 0 ratings (No growth)
VOC content (USEPA Method 24): ~25 g/L

Usage Instructions

1. Surfaces must be clean, dry and free of dirt, grease, oil or water.
2. Surfaces should be cleaned with alcohol, M.E.K. or other suitable solvents. Do not use soap or detergent.
3. For a neat finish, apply masking tape and remove it before sealant skins over.
4. Cut nozzle at 45° angle to the desired bead-width and apply to a substrate with a cartridge gun.
5. Tool the sealant within 10 minutes of extrusion before it skins. Tack-free in 20 minutes.
6. Uncured sealant can be cleaned up with mineral spirits.

Clean Up

  • Wet sealants can be cleaned up with acetone or mineral spirits.
  • Cured sealants can only be removed mechanically.

Joint Design

  • The specified sealant bead size should be calculated to comply with the compression and extension capabilities of the sealant in relation to the anticipated joint width due to expansion and contraction.
  • Generally, calculation of the width sealant bead should be computed on the basis of a maximum ±20 %movement capability
  • Minimum joint depth should not be less than 6 mm to accommodate movement.
  • Sealant design joint width-to-depth ratio should be 2:1.

 

Ask us

If you have any questions or suggestions, please fill the form below, and we get back to you as soon as possible

Please use the form below or contact Us directly via email.

Call Us

If you have any questions or wish to be served outside of trade hours, please call us:
+61 4  2220 6530 or +61 2 8119 5343.